I know I can get them cheep, but the adapter plates are to much, and not figured in to my budget at this time. Easy upgrade at any time.

Got the inlet at 82mm, can't do anything with the butterfly valve.


Internal MAF is gone, made a cover plate


Hole is sealed. Waiting for the JB weld to harden and then it'* polish time

Just need to put it together. I'll have to get that later on


So, why am I doing this instead of driving or tuning the Bonneville? Easier to show.


Been clearing snow all day. This is my winter ride.


There is a driveway in there somewhere. And it'* been plowed once already. I'm off to clear it again.

Dan...what are you plowing the driveway with?

My neighbor has a jeep wrangler, I've got a snow thrower.

When I went to pick up some JB weld I was walking along and I saw this, wow, something I don't have. Must have.


Throttle body is all done. I'll pick up a few hose clamps tomorrow and get it put on the car.






I've already added the LS1 MAF curve to my bin file. Once installed I'll transfer over the new bin and she should be all ready to go.

Looking great Dan! Can wait to hear what the butt dyno says.

It looks like it'* coming along fine! Your build trail is going to make things easier for me as I try to catch up

And the two of you will make it easier for me to pass you Tom!

Good luck passing me. I'm still trying to catch Bill.

Dead red top has me sitting still at the moment. I'm easy to keep up to.

til I tap the throttle