lol
So this means I have to go shopping?

Those little security torx bits are cheap at the hardware store Kind of defeats the purpose huh?

Took the TB off on Saturday, got to working on it today, bought a few bits for the dremel tool.
All in all, it went pretty good, a machine shop could of done this much faster, and much sharper, however, I did gain some room in there for sure.
I left the stock retaining bolts in place for now, until i get some flat ones.
Took about 1.5 hrs total, hand breaks included

Before

After

Which bits did you use?

take off the long ends of those throttle plate screws

Regardless of what screws I use, i will make them short enough so they sit flush.
I used a Multipurpose cutting bit, its round with tiny little blades on it.

Damn, All this supercharger talk
Mine is coming off this weekend for sure, I hope the ole Motomaster Rotary tool hangs on...
Furnace is now on inside the garage!

what is the Butter knife for??

I was in a pinch for a flathead screw driver
Don't ask, learn. Buy lots of screwdrivers, you'll lose them, it sucks, alot!

Co-workers ask me why I have a steak knife in my tool pouch when I'm working with Fiber Optics.



yeah, the joke is on them when I tell them it gives the cleanest cut on fiber.