1997 SSEi Performance Build up Time Update 2/5/07new mod!!
Kind of defeats the purpose huh? 
11-19-2006, 08:22 PM
#53
Senior Member
True Car Nut
Thread Starter
Join Date: May 2003
Location: Lethbridge, Alberta, _______Canada._______ West Coast Bonneville Fest ___05,06,07 Survivor___
Posts: 8,135
Likes: 0
Received 0 Likes
on
0 Posts
Took the TB off on Saturday, got to working on it today, bought a few bits for the dremel tool.
All in all, it went pretty good, a machine shop could of done this much faster, and much sharper, however, I did gain some room in there for sure.
I left the stock retaining bolts in place for now, until i get some flat ones.
Took about 1.5 hrs total, hand breaks included
Before
After
All in all, it went pretty good, a machine shop could of done this much faster, and much sharper, however, I did gain some room in there for sure.
I left the stock retaining bolts in place for now, until i get some flat ones.
Took about 1.5 hrs total, hand breaks included
Before
After
11-19-2006, 09:05 PM
#56
Senior Member
True Car Nut
Thread Starter
Join Date: May 2003
Location: Lethbridge, Alberta, _______Canada._______ West Coast Bonneville Fest ___05,06,07 Survivor___
Posts: 8,135
Likes: 0
Received 0 Likes
on
0 Posts
Regardless of what screws I use, i will make them short enough so they sit flush.
I used a Multipurpose cutting bit, its round with tiny little blades on it.
I used a Multipurpose cutting bit, its round with tiny little blades on it.
11-22-2006, 11:51 PM
#57
Senior Member
True Car Nut
Thread Starter
Join Date: May 2003
Location: Lethbridge, Alberta, _______Canada._______ West Coast Bonneville Fest ___05,06,07 Survivor___
Posts: 8,135
Likes: 0
Received 0 Likes
on
0 Posts
Damn, All this supercharger talk
Mine is coming off this weekend for sure, I hope the ole Motomaster Rotary tool hangs on...
Furnace is now on inside the garage!
Mine is coming off this weekend for sure, I hope the ole Motomaster Rotary tool hangs on...
Furnace is now on inside the garage!
11-22-2006, 11:56 PM
#59
Senior Member
True Car Nut
Thread Starter
Join Date: May 2003
Location: Lethbridge, Alberta, _______Canada._______ West Coast Bonneville Fest ___05,06,07 Survivor___
Posts: 8,135
Likes: 0
Received 0 Likes
on
0 Posts
I was in a pinch for a flathead screw driver
Don't ask, learn. Buy lots of screwdrivers, you'll lose them, it sucks, alot!
Don't ask, learn. Buy lots of screwdrivers, you'll lose them, it sucks, alot!
11-23-2006, 02:52 AM
#60
Senior Member
True Car Nut
Join Date: Dec 2002
Location: Sauk Centre, MN
Posts: 5,459
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 1993 SLE
what is the Butter knife for??
yeah, the joke is on them when I tell them it gives the cleanest cut on fiber.
