didnt do anything on the truck today because gm put some kind of stupid quick connects on the trans that im going to have to order and wait for, so i guess the truck is going to be laid up for a while.

Just finished up a r f wheel brg on 04 GP told the friend 45 min. to do it I beat my est. by a few minutes / netted a 30 pack for it . only broke 1 13mm socket and kept all my skin and blood. lol

LOL, I told a guy who lives two hours away that I'd do his wheel bearings if he drove to me. I owed him for looking at a car for me.

Took about an hour per bearing. The bolts were nearly frozen. I pulled out the big (3ft) ratchet and on the passengerside had to pull the balljoint apart to get a better angle on it. Ridiculous...

Today: I think I'm stopping off and picking up a new mirror assembly. Need a motor (turkey busted a couple clips I didn't notice the other day) and the glass. Driving w/o a mirror is torturing me. Likely the Bonne will be back up and running again tonight.

Nearly finished SSExi.

Fuel pump is done truck is runing again all good to go..Now heading back out to finish putting new intake gaskets on my dads truck!

I backed SSExi out in to the parking lot so I could clean up the shop floor, then drove it back in to the shop.

I, FINALLY, finished the body work on my truck. I finished the hood last night. If I would of had help then I would have worked on the hood off the truck, but instead I did everything to it while it was on the truck. I started to put a new sending unit in my gas tank, but the sock filter didn't go on right and when I took it back off I broke it. (Stupid is as stupid does.)

Just about finished with a LIM gasket, UIM replacement. It'* a little sad that I can do this job so fast at this point.

2.5 hour job for me.

Put alot of miles on the intrepid lol