I am replacing my rack and pinion on my 2004 Pontiac Montana. I would like to know if anyone will have the 12 specifications on the rack and pinion. From the ball joints to the rack and pinion mount only other torque specification. Regarding the rack and pinion. thank you all I appreciate it.

Maybe someone here has them, but just in case you're pressed for time: Put them on a little tighter than you took them off.

tener Specifications
Fastener SpecificationsApplication

Specification

Metric

English

Cooler Pipe Retainer Bolt/Screw
89 lb in

Inner Tie Rod
74 lb ft

Power Steering Gear Adjuster Plug Lock Nut
20 lb ft

Power Steering Gear Cylinder Line Fittings
50 lb ft

Power Steering Gear Heat Shield Bolts
62 lb in

Power Steering Gear Nuts – at Frame ¹
44 lb ft + 60°

Power Steering Gear Valve End Fitting
13 lb ft

Power Steering Hose/Pipe Fittings
20 lb ft

Power Steering Pump Bolts
22 lb ft

Power Steering Pump Flow Control Valve
55 lb ft

Rear Frame to Body Bolts
122 lb ft

Tie Rod Ball Stud Nut ¹ ²

• First Pass

22 lb ft

• Final Pass

+ 120°

¹ This is a prevailing torque type fastener. This fastener may be reused ONLY if:

• The fastener and its counterpart are clean and free from rust
• The fastener develops a specified amount of torque/drag against its counterpart prior to the fastener seating.Refer to the appropriate service procedure for the prevailing torque value.
  

If the fastener does not meet these criteria, REPLACE the fastener.

² Ensure that 2.5–4.5 tie rod end threads are visible beyond the tie rod ball stud nut nylon.

Thanks dpieroni3!

Luis, you good?