Installed new pulley, slight kr
Thread Starter
Member
Posts like a V-Tak
Joined: Jun 2007
Posts: 69
Likes: 0
From: Plymouth WI
Installed new pulley, slight kr
well i finally decided to install a 3.5 pulley on my car. the car is entirely stock besides the pulley. the only time i see KR is at WOT. i see 1 degree at higher rpm just before the 1-2 shift, and then 1 degree halfway to 2-3 shift and 2 degrees till the shift into 3rd the timing advance is around 16 degrees at WOT right before shifts.. just wondering, do you guys think that a fwi and high flow cat would take care of my kr?
BANNED
Joined: Mar 2004
Posts: 0
Likes: 5
From: Purgatory
http://www.intense-racing.com/Mercha...roduct_Count=0
INTENSE™ Standard PCM - $99.99
Ideal for stock to slightly modded cars with induction mods, exhaust mods, smaller supercharger pulley and/or rocker arms - features removal of all speed limiters, higher shift points (~6,000 RPM)** and rev limiter (6,200 RPM) , proprietary transaxle shift behavior adjustments** including 'skip shifts', air/fuel adjustments, knock retard decay rate adjustment, cooling fan control adjustments (180°), cooling fans on at key-off for 180 seconds, elimination of Abuse Mode, Differential Scoring Protection, Supercharger Torque Management, etc.
Ideal for stock to slightly modded cars with induction mods, exhaust mods, smaller supercharger pulley and/or rocker arms - features removal of all speed limiters, higher shift points (~6,000 RPM)** and rev limiter (6,200 RPM) , proprietary transaxle shift behavior adjustments** including 'skip shifts', air/fuel adjustments, knock retard decay rate adjustment, cooling fan control adjustments (180°), cooling fans on at key-off for 180 seconds, elimination of Abuse Mode, Differential Scoring Protection, Supercharger Torque Management, etc.
Thread
Thread Starter
Forum
Replies
Last Post
Glasuan
Performance, Brainstorming & Tuning
8
Oct 15, 2004 10:05 AM
Paulnold
Performance, Brainstorming & Tuning
9
May 4, 2004 12:36 PM