Figure i'll post my project since i used your supercharger.
Thread Starter
Member
Posts like a V-Tak
Joined: Mar 2007
Posts: 91
Likes: 0
Originally Posted by harofreak00
how much space did you leave between the needle bearings and where you cut?
I'm sorting out relocating the throttle body, so far it'* going okay. Probably will be going next week, my girlfriend'* birthday is in the way of tomorrow and my friend'* wedding is the day after, plus another friend'* birthday.
Thread Starter
Member
Posts like a V-Tak
Joined: Mar 2007
Posts: 91
Likes: 0
Originally Posted by O 16581 72452 5
Accompishment today.
Helped a friend pull a motor from his car, helped another friend swap seats in his car.
Accomplishments to my car.
0
:(
Helped a friend pull a motor from his car, helped another friend swap seats in his car.
Accomplishments to my car.
0
:(
Begi is sooooo cheap internally.
Thread Starter
Member
Posts like a V-Tak
Joined: Mar 2007
Posts: 91
Likes: 0
Originally Posted by caminated2k
ttt.
Interested in how you have it setup in the end.
Interested in how you have it setup in the end.
Still running pig rich. I think i'm going to invest in an SAFC and put my wideband in.
Thread Starter
Member
Posts like a V-Tak
Joined: Mar 2007
Posts: 91
Likes: 0
Originally Posted by caminated2k
I'm tellin ya... the MAF is not reading properly. Sure you can scale it back but at WOT it WILL read right... so you have to have it be variable....
Good luck!
Good luck!
Senior Member
Posts like a Turbo
Joined: Jun 2004
Posts: 287
Likes: 0
Originally Posted by O 16581 72452 5
Originally Posted by caminated2k
I'm tellin ya... the MAF is not reading properly. Sure you can scale it back but at WOT it WILL read right... so you have to have it be variable....
Good luck!
Good luck!
