2003 Chevy Silverado 2500hd
Senior Member
True Car Nut
Joined: Feb 2015
Posts: 6,851
Likes: 1,015
From: Earth
Sounds like a solder joint is bad. Stepper motors will do that if they're commanded to step one way and not the other.
Just checking: you are experienced with soldering electronics, unsoldered the old stepper motor from the circuit board, cleared excess solder, cleaned the pads, then soldered the new one in?
Just checking: you are experienced with soldering electronics, unsoldered the old stepper motor from the circuit board, cleared excess solder, cleaned the pads, then soldered the new one in?
Thread Starter
Member
Posts like a V-Tak
Joined: Sep 2018
Posts: 30
Likes: 0
From: Buffalo
i have never done them I have had the truck for 3 years, I don’t know if it is the original gasket, wouldn’t it misfire in overdrive though if it was intake gasket, why only in tow mode and 3rd when it stays steady at 3000 rpm
Thread Starter
Member
Posts like a V-Tak
Joined: Sep 2018
Posts: 30
Likes: 0
From: Buffalo
Senior Member
True Car Nut
Joined: Feb 2015
Posts: 6,851
Likes: 1,015
From: Earth
Senior Member
Posts like a Supercharger
Joined: Feb 2015
Posts: 185
Likes: 50
If your getting high rpm misfires and can not duplicate it at idle or on a brake torque. Can you see what cylinders are misfiring by raising the rpm in park or neutral? If it'* only a couple of cylinders like 2 and 5 drop out and counts up constantly for example,try doing a crankshaft variation learn procedure with a scan tool. I have cured many P0300 by doing so.
Also these will develop high rpm misfires due to valve issues. Do a compression test and watch the 1st puff, (that'* the important one)after that one the compression will raise to match the others, and compare to one that isn't misfiring and see if it'* less.I have also found that I usually wont see it with a leak down test. Hope you find this helpful.
Also these will develop high rpm misfires due to valve issues. Do a compression test and watch the 1st puff, (that'* the important one)after that one the compression will raise to match the others, and compare to one that isn't misfiring and see if it'* less.I have also found that I usually wont see it with a leak down test. Hope you find this helpful.
Thread Starter
Member
Posts like a V-Tak
Joined: Sep 2018
Posts: 30
Likes: 0
From: Buffalo
If your getting high rpm misfires and can not duplicate it at idle or on a brake torque. Can you see what cylinders are misfiring by raising the rpm in park or neutral? If it'* only a couple of cylinders like 2 and 5 drop out and counts up constantly for example,try doing a crankshaft variation learn procedure with a scan tool. I have cured many P0300 by doing so.
Also these will develop high rpm misfires due to valve issues. Do a compression test and watch the 1st puff, (that'* the important one)after that one the compression will raise to match the others, and compare to one that isn't misfiring and see if it'* less.I have also found that I usually wont see it with a leak down test. Hope you find this helpful.
Also these will develop high rpm misfires due to valve issues. Do a compression test and watch the 1st puff, (that'* the important one)after that one the compression will raise to match the others, and compare to one that isn't misfiring and see if it'* less.I have also found that I usually wont see it with a leak down test. Hope you find this helpful.
Thread
Thread Starter
Forum
Replies
Last Post
