S10 V8 exhaust
#1
Retired
Thread Starter
S10 V8 exhaust
http://www.summitracing.com/parts/SUM-680126
It'* in Buffalo right now, should be here tomorrow.
I plan on installing it this Saturday at our shop. Hopefully I can get most of it done in 4ish hours cause that'* how long our parts department is open/but the shop is closed.
It'* in Buffalo right now, should be here tomorrow.
I plan on installing it this Saturday at our shop. Hopefully I can get most of it done in 4ish hours cause that'* how long our parts department is open/but the shop is closed.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#4
Retired
Thread Starter
Yes, we a have long style Bendpack that you can drive onto and a standard lift.
Yes, my headers have 2.5" collectors.
$177.95 S10 V8 4wd Conversion Headers
But the problem is, my headers are of the flange style, and the exhaust is setup for Hedman style headers. So, i'm going to have to cut the ball end off the exhaust, weld on a 2" piece at each end and then weld that to the collector piece.
Yes, my headers have 2.5" collectors.
$177.95 S10 V8 4wd Conversion Headers
But the problem is, my headers are of the flange style, and the exhaust is setup for Hedman style headers. So, i'm going to have to cut the ball end off the exhaust, weld on a 2" piece at each end and then weld that to the collector piece.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#5
Senior Member
True Car Nut
http://www.summitracing.com/parts/hed-21105
would be alot easier. or if you stop by a performance shop "2.5inch header reducers" pretty popular and should be in stock
would be alot easier. or if you stop by a performance shop "2.5inch header reducers" pretty popular and should be in stock
#6
Retired
Thread Starter
Yea, those are the pieces I was referring to.
I will need to cut the part circled in red off, then weld the reducer to the pipe.
I will need to cut the part circled in red off, then weld the reducer to the pipe.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#8
Retired
Thread Starter
No sir.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Thread
Thread Starter
Forum
Replies
Last Post
givemebreak
Your Ride: GM Pictures & Videos
14
07-22-2005 12:05 PM
givemebreak
Your Ride: GM Pictures & Videos
28
04-10-2005 09:07 AM