cam sensor, the code says low cam sensor return voltage. which i think on those goes to the icm then pcm

OK I will check out both ends of the cam sensor wiring. I will also replace the old one with the new one that did not make a difference before check the magnet in the cam gear and see what happens. Again mucho gracias for fine, quick response.

Update: I checked out the leads coming to the cam position sensor and the crank pos sensor. Moving the wiring around a lot did not show any broken wires. Cam and Crank sensors were replaced as was the Ignition Control Module. cam pos sensor magnet in place and strong. car will start dead cold but won't run more than about a minute or so. I am now wondering if I have a main computer problem or wiring in between. Going away for awhile and will have to look into this later on. Thanks to all for the help that has been given freely.