Antenna end size in trunk
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Nov 2002
Location: Pleasant Bend, Ohio
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Antenna end size in trunk
I am getting an FM modulator and am wondering about the size of the antenna end at the power antenna motor in the trunk (GM small or normal), and if is designed to come out. If I could avoid the cost of using adapters I will. The modulator has enough wire to run to the interior. I assume running it behind the radio means I will have to buy adapters...
Thanks!
Coop
Thanks!
Coop
#2
Senior Member
Posts like a 4 Banger
Join Date: Jun 2006
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
Well, I dunno if this is really relevant, but I recently replaced my power antenna and it came out fine. The main motor should be attached with 2 screws on a bracket, and the antenna screws in with a couple nuts here and there.
If this is what you wanted to know, or need more info, I'll be happy to try and help
Also, I'm not entirely sure how big it is, but it'* easy to check... just open the trunk and pull out the trunk liner on that side near the wheel well and it should be right there.
If this is what you wanted to know, or need more info, I'll be happy to try and help
Also, I'm not entirely sure how big it is, but it'* easy to check... just open the trunk and pull out the trunk liner on that side near the wheel well and it should be right there.
#3
Member
Posts like a V-Tak
Thread Starter
Join Date: Nov 2002
Location: Pleasant Bend, Ohio
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Thanks! And yes, the antenna end is "normal non-GM" size. If the wire is long enough, I won't have to take the radio out or get adapters...
Thread
Thread Starter
Forum
Replies
Last Post
SilverSleeper8704
Audio (and aftermarket electronics)
2
07-23-2012 06:52 AM
BarryBoy
Audio (and aftermarket electronics)
0
12-01-2007 11:10 PM
Mark Peters
Performance, Brainstorming & Tuning
10
03-21-2003 08:42 PM