Trouble code 361??
10-27-2003, 07:26 PM
#11
Senior Member
True Car Nut
Join Date: Sep 2002
Posts: 3,392
Likes: 0
Received 0 Likes
on
0 Posts
Autozone stores appear to have leftover stock at a great price. Otherwise you're looking at www.actron.com
10-27-2003, 07:34 PM
#14
Senior Member
Posts like a Turbo
Join Date: Mar 2003
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by jkinney
Thanks Fuddyduddy121, I guess it would help if I would READ the damn page. 
-SSEi95- If it wouldnt be any trouble, I'd like to hear what it says, I doubt if it will be alot different than the 94'*, at least it will give me something to troubleshoot. NAPA did check the module today, and it checked out GOOD.
Hmmm. The mounting plate did seem to be extra corroded from the dielectric grease dissolving, so I will try to clean, re-grease, re-install, and re-check. If it doesnt improve, I'll continue from there.
95neongirl- Are you considering picking one up?
-SSEi95- If it wouldnt be any trouble, I'd like to hear what it says, I doubt if it will be alot different than the 94'*, at least it will give me something to troubleshoot. NAPA did check the module today, and it checked out GOOD.
Hmmm. The mounting plate did seem to be extra corroded from the dielectric grease dissolving, so I will try to clean, re-grease, re-install, and re-check. If it doesnt improve, I'll continue from there.95neongirl- Are you considering picking one up?
10-27-2003, 07:34 PM
#15
Senior Member
True Car Nut
Join Date: Sep 2002
Posts: 3,392
Likes: 0
Received 0 Likes
on
0 Posts
If you had significant corrosion on the contacts, that could very well be the culprit. Something else to remember - sometimes engine heat can make a problem appear that would not be there in lower temperatures.
10-27-2003, 10:33 PM
#16
Senior Member
Posts like a 4 Banger
Thread Starter
Join Date: Sep 2003
Location: Lebanon, Indiana
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
I didn't think codes went that high? Check your plugs/wires/coils i assume?
I did put new delco plugs in it when I purchased the car, but havent done wires yet. Not sure that would set off a code for "EST not toggling", but it would be a cheap investment (wires) Thanks for the responses, I'll keep going after it till I find what it is, the wife wants to drive it pretty bad. 
(right) The code triggers immediately on a cold start (after clearing) so I dont think heat is a factor at this point. I'll keep you posted.
Thread
Thread Starter
Forum
Replies
Last Post
riotact
Performance, Brainstorming & Tuning
6
06-22-2003 07:11 PM