Starter Enable Relay
Hi can anyone tell me where to put the resister on 1995 buick la sabre that will not start it will if you turn the key on and wait for 3 minutes but it will also stop after about 5 sec!! like the previous posting of Bonnie Canuk thanks wait your directions thanks Mike B.
Senior Member

True Car Nut
Joined: Sep 2006
Posts: 4,816
Likes: 245
From: Windsor, Ontario / Detroit, Michigan









Spot on , the 1993 ELECTRICAL SYSTEM MANUAL IS WRONG. The 93 is as shown and secured by two 5mm screws . mine had one. The black box has a with dimensions 4.5 X 3 X 1.25 " . Green 16 pin connector with a squeeze tab for disconnecting the module. . White label "PASS-KEY II' wit a PN number. ?
Passkey on column replaced both white wires are good with correct resistor key. No SECURITY LIGHT? Key on bridge the starter solenoid with screw driver, Tries to briefly start, will not run. Next my plan is to bridge the relay contacts 30 to 87. This should? bypass Passkey system? Footnote. not sure for my lower dash is removed. Removing the glove box may allow removal of this module?
Passkey on column replaced both white wires are good with correct resistor key. No SECURITY LIGHT? Key on bridge the starter solenoid with screw driver, Tries to briefly start, will not run. Next my plan is to bridge the relay contacts 30 to 87. This should? bypass Passkey system? Footnote. not sure for my lower dash is removed. Removing the glove box may allow removal of this module?
Thread
Thread Starter
Forum
Replies
Last Post



