CV Boot
#11
Senior Member
Posts like a Corvette
Thread Starter
Join Date: Nov 2005
Location: Hamilton, Ontario , Canada
Posts: 1,201
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the info guys, Ill make some calls and see what I can get for drive axle .This weekend is shot I work all weekend 12 hr days.
#13
Senior Member
True Car Nut
Join Date: Feb 2005
Location: Brampton, Ontario
Posts: 3,014
Likes: 0
Received 0 Likes
on
0 Posts
If you can wait about a week and a half and your willing to drop by my place since I have all the air tools and torque wrenches, I'd be willing to give you a hand.
#14
Senior Member
Posts like a Corvette
Thread Starter
Join Date: Nov 2005
Location: Hamilton, Ontario , Canada
Posts: 1,201
Likes: 0
Received 0 Likes
on
0 Posts
Thanks MMBLF, i WILL probably give it a shot this weekend as I am off.The power tools would be great, guess Ill use manual tools and elbow grease.Ill get er though.Thanks again.
#15
Senior Member
True Car Nut
Join Date: Feb 2005
Location: Brampton, Ontario
Posts: 3,014
Likes: 0
Received 0 Likes
on
0 Posts
I don't remember if you mentioned it before, but is it for the 1990, or the 2000? Hamilton is about an hour away from me, where abouts are you located? Please don't tell me it'* up on the mountain.
#17
Senior Member
True Car Nut
Join Date: Feb 2005
Location: Brampton, Ontario
Posts: 3,014
Likes: 0
Received 0 Likes
on
0 Posts
Someone so graciously sent me a pm basically telling me ........Uh.......Frank, he posted in the 1987 to 1991 section so it'* safe to say it'* for the 90.....Daaaaaah.
I guess I should have taken the time to look more carefully. My Bad.
I guess I should have taken the time to look more carefully. My Bad.
#19
Senior Member
True Car Nut
Join Date: Feb 2005
Location: Brampton, Ontario
Posts: 3,014
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by jdq
Yes sir Im on the mountain , its for the 90 .
You had to say the mountain didn't you. If you run into problems call me, your only an hour away. If interested pm me and I give you my home number. Do you have:
Jack
Stands
Split fork for the lower ball joint
Torque wrench
Cotter pin for lower ball joint
34mm socket, preferably 1/2" drive
The rest of the tools I assume you have.
#20
Senior Member
Posts like a Corvette
Thread Starter
Join Date: Nov 2005
Location: Hamilton, Ontario , Canada
Posts: 1,201
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Maymybonneliveforever
Originally Posted by jdq
Yes sir Im on the mountain , its for the 90 .
You had to say the mountain didn't you. If you run into problems call me, your only an hour away. If interested pm me and I give you my home number. Do you have:
Jack YES
Stands YES
Split fork for the lower ball joint YES
Torque wrench YES
Cotter pin for lower ball joint GOING TO GET
The rest of the tools I assume you have.
WHAT is wrong with the mountain.This weekend isnt 100%, wife reminded me of a few things we gotta do.Thanks for replies.Oh I read your old post I guess I need to make sure I have female to male at the trans.