Ok, So i have my PCM tray on order, have a 3.5inch K&N filter, and now i need to find something that will make a suitable template that i can bend to shape to snake through the fenderwell and hold its shape while i take it to an exhaust shop to have a piece of Stainless Steel pipe bent for it.....

I would do the intense tubing route, becasse you need flex, espically since yout doing the FWI

Yep....

Intense tubing would be better. You need the flex beacuse of the touque.

Check out Wills video of "Greenzilla"

http://www.williamwren.com/flex.mpg

no offense to intense and any of those out there using their intake tubing but THAT **** IS GHETTO and WAY overpriced.. im not worried about the flex, i have it all planned out in my equasion..

ok cool, as long as you thought about it, you should be good to go

Use a coat hanger or simillar sized wire to form the top of the pipe, remember to allow for extra length when bending pipe. This will depend on pipe diameter and radius of bend.
I used to be an industrial electrician and have used this method many times on tricky pipe bends up to 6".