I don't have one, so I can't give you a good answer. I do remmeber it'* something like unpop a few clips, one or two screws and it lifts up.

Found it
Removal Procedure

1. Remove the inside door handle bezel. Refer to Door Inside Handle Bezel Replacement .
   
   
2. Remove the upper door trim panel.
   2.1. Use the J 38778 in order to release the retainer at the top of the upper door trim panel.
   2.2. Lift the upper door trim panel upwards in order to remove.
   2.3. Disconnect the wire harness to the tweeter.
   
   
   
3. Use the J 36796 in order to release the retainers around the outside edges of the door trim panel. Start at the bottom and work around.
   
   
4. Starting at the bottom rear of the door trim panel pull inwards, while lifting upwards in order to remove.
5. Disconnect the door trim panel wiring harness.
   
   
6. Remove the armrest pull cup retainers from the inside of the door trim panel.
   6.1. Use needle nose pliers to compress the 360 clip.
   6.2. Pull the 360 clip out of the nylon nut on the door trim panel.

Installation Procedure

1. Install the 360 clip retainers into the nylon nuts on the inner door panel.
2. Connect the door wire harness to the door trim panel wire harness.
   
   
3. Starting at the bottom, secure the door trim panel around the outside edges with the retainers (2).
4. Align the door trim panel to the 360 clip retainers (1).
5. Snap the retainers in to secure the center of the door trim panel to the inner door panel.
6. Pull on the armrest to assure proper fit.
7. Push outwards near the top of the door trim panel in order to snap the top door trim panel retainer into the channel in the window inner belt seal strip.
8. Install the inside door handle bezel. Refer to Door Inside Handle Bezel Replacement .
   
   
9. Install the upper door trim panel (1).
   9.1. Connect the wire harness to the tweeter.
   9.2. Insert the tabs into the slots on the door trim panel.
   9.3. Insert the retainer into the hole in the door frame.

thanks bill!! it helped alot!

one side is done and wired up

passenger side hopefully by next week

more videos to come soon

that looks awesome!! i want some what bulbs did ya use for the red directionals in the tails?

thanks!!
easy mod! you should start on it

this bad guy

http://www.v-leds.com/Exterior-LED/B...-p7470633.html

Came out really good Sam.

thanks!
one side done, and one to go

Oh man..I was going to crack a joke about not doing a vid on the other side because you hadn't done it. But figured it was in bad taste and you really only needed to show us one side.

I was sure you had it done.

no i broke the mirror :( waiting on replacement lol