4th Engine coming up- L36 to L67 Swap
#61
Retired
Thread Starter
I FINALLY got my update this morning. I spent the last hour or so, recalibrating my file with L67 settings. That causes carpal tunnel to kick in I tell ya!
Dan, question for ya. I didn't change anything in the Speedo section of the editor. Right now, my PCM has the stock "General, Limiter, Gear/Tire Calc" settings. The new transmission is different. 3.29FD. Rotor=30 Sprockets-Drive/Driven=37/33. (found this in my ATSG manual)
What do I need to change in those tabs to reflect the new trans?
Dan, question for ya. I didn't change anything in the Speedo section of the editor. Right now, my PCM has the stock "General, Limiter, Gear/Tire Calc" settings. The new transmission is different. 3.29FD. Rotor=30 Sprockets-Drive/Driven=37/33. (found this in my ATSG manual)
What do I need to change in those tabs to reflect the new trans?
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#63
Retired
Thread Starter
Ok, thanks Dan. I'll give that a try and see what happens here in a few.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Thread
Thread Starter
Forum
Replies
Last Post
DJ SHO
Performance, Brainstorming & Tuning
7
07-19-2004 03:39 PM