OMG....nice switch and LED setup- --------------------------------------------------------------------------------------------------^

it that alum tape ??????

anyway im sure that there is somethig that is doable with that HUD pod.....i have a few ideas my self

Yup. Foil, duct....whatever tape works. It was quickly fabbed last year just before summer and I haven't had a chance to modify it but it serves its purpose.

Don't keep those ideas to yourself......speak up

Paul, move the injection switch and LED'* to the new pod. Get a smaller switch. Combine it all in one unit.

yes see that "button" on the gague pod....use that for a switch location....and drill the LED'* in the Gague pod, or drill the LEDs into the vent to the right of the upper vent...

can you get a better pic of the HUD pod in daylight? i need to see better pics to see exactly you have to modify and what you have to work with

so far I think the hud pod would fit better on a 92-99.

If you trim the lower corner, that would help a little. Then I think it'* add material time.

I'd definitely be getting out the fiberglass to re-shape that pod.

http://www.bonnevilleclub.com/forum/...fiberglass+pod

Good ideas on combining the gauge and water injection switch/leds.

I'll have to work on modifying the pod to fit better.

yup it will look better

and im not so sure that the Fiberglass is the best option...i used bondo for my Pillar Pod and its easire to mold and sand comapred to the fiberglass
Here is my pillar
http://www.bonnevilleclub.com/forum/...teh+pillar+pod

Can we please split off the pod talk from the supercharger coating? I'm sure others would benefit from it.

I'll figure a good spot to split this, and post a link in this topic back to the other one (which is really going to be this one after the split).

Bondo is great for blending and such. Not for adding material like Paul needs to do. That should be done with fiberglass. You want structural strength for the amount of material he'll need to add.