95 lumina apv 3.8 v6 died no fire
Thread Starter
Junior Member
Joined: Mar 2017
Posts: 8
Likes: 0
95 lumina apv 3.8 v6 died no fire
I have a 95 lumina van with 3.8 that was running rough then died last week.I got it towed home the next day and started right up ran for about a minute then died again.I checked the fire and 2 of the coils fired good but no fire from the coil for the number1 and4 cylinders.got a new coil and replaced it still won't start and no fire from the new coil.any help would be greatly appreciated in the last18 months I have replaced the ignition module twice all 3 coils crank sensor fuel pump and computer
Senior Member
True Car Nut
Joined: Feb 2014
Posts: 2,878
Likes: 1,097
From: Worcester, Ma.
If the other two coils are firing, that means the crank sensor is ok....the fact 1/4 isn't firing, even with a new coil, means the ICM is bad.....AGAIN!
What kind of ICM'* have you been using?
What kind of ICM'* have you been using?
Thread Starter
Junior Member
Joined: Mar 2017
Posts: 8
Likes: 0
took the icm and coils to auto zone and everything tested good it tries to start and backfires a little
Senior Member
True Car Nut
Joined: Feb 2014
Posts: 2,878
Likes: 1,097
From: Worcester, Ma.
Well, I see this happen a lot.....remove from vehicle and it tests out ok....put back in the car and it fails....even you said it ran fine for a minute.....
One thing you did not mention was the wires/plugs.......are they new?
One thing you did not mention was the wires/plugs.......are they new?
Last edited by Tech II; Jan 20, 2018 at 09:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post
L67Silhouette
Lounge
0
Sep 17, 2007 12:44 AM