93 lumina apv van front door glass guide "clip"
Thread Starter
Member
Posts like a V-Tak
Joined: Jan 2008
Posts: 40
Likes: 0
From: IL
93 lumina apv van front door glass guide "clip"
whats dorman part num for the front-most black little plastic front door glass guide that pops into the front glass track? the ones that fold in half around the edge of the window and pop into the hole. i see that they are different from the truck ones like S10 and C1500 and etc... and i see that some like number 700-871 say they are screw on? how is that possible?? hmm... 
!
!
Thread Starter
Member
Posts like a V-Tak
Joined: Jan 2008
Posts: 40
Likes: 0
From: IL
93 lumina apv front seat belt retractors stuck out.
93 apv the front belt retractors are pulled out all the way and stuck. whats the fix? this is a federal safety issue shouldnt this be a service recall? they did it for the early 80s camaros with bad buckle buttons. so..
Senior Member
True Car Nut
Joined: Feb 2014
Posts: 2,878
Likes: 1,097
From: Worcester, Ma.
Try tugging real hard and the mechanism may release...there is a pendulum in there that acts like ratchet....sometimes removing the torx 50 bolt and removing the retractor and holding it at various angles and tugging on the belt will release it...
Senior Member
True Car Nut
Joined: Feb 2014
Posts: 2,878
Likes: 1,097
From: Worcester, Ma.
I remember those.......you would put them in hot water to soften them up.....then slide it through the hole in the glass, and then bend them together...
Your best bet is to try a GM dealership, or communicate online with something like RockAuto, to see if they are still available....
Your best bet is to try a GM dealership, or communicate online with something like RockAuto, to see if they are still available....
Thread Starter
Member
Posts like a V-Tak
Joined: Jan 2008
Posts: 40
Likes: 0
From: IL
theyre both pulled all the way out totally no slop or give AT ALL. ive already tried pulling yanking endlessly and its fruitless.
Thread Starter
Member
Posts like a V-Tak
Joined: Jan 2008
Posts: 40
Likes: 0
From: IL
I remember those.......you would put them in hot water to soften them up.....then slide it through the hole in the glass, and then bend them together...
Your best bet is to try a GM dealership, or communicate online with something like RockAuto, to see if they are still available....
Your best bet is to try a GM dealership, or communicate online with something like RockAuto, to see if they are still available....
Thread
Thread Starter
Forum
Replies
Last Post
L67Silhouette
Lounge
0
Sep 17, 2007 12:44 AM