JB Weld and Fuel
Senior Member
Certified GM nut
Joined: May 2005
Posts: 2,155
Likes: 0
From: Wickliffe, Ohio
I'd call Mr. Morad and get a rail or braze your current one like stated by others. Curt mentioned 50% silver solder, we use 100% silver solder in my shop with the torches we build and it'* really strong stuff.
Ed
Ed
Thread Starter
Senior Member
Posts like a Northstar
Joined: Jul 2006
Posts: 508
Likes: 0
From: Meridian, ID
I went out and bought some MAPP gas and brazed them today. Turned out pretty good I think. Don't see any holes, but after they are cooled down a bit I will pressure test them. I ordered my AN fuel lines today from Jegs so hopefully I can get this project going next week.
Here is a pic of the progress:
Here is a pic of the progress:
Thread
Thread Starter
Forum
Replies
Last Post