Well I have to replace it. Anyone can give me tips? How do I get to it? Pics would be good to.

Remove the door trim panel. You will need the tools to pop the clips.

Remove the door module. This is in the lower rear corner of the door.

Remove the water deflector. This is the plastic cover.

Loosen the window retainer to window clamp fasteners 4 revolutions.

Lower the window regulator about half way down.

Disconnect the electrical connector from the power window motor.

Remove the window regulator to inner door panel fasteners 2 near the bottom and one up top

Remove the window regulator.

Tilt the motor end of the window regulator to the forward end of the door.

Tilt the top of the regulator toward the lower rear corner of the door.

Remove the regulator through the front access hole in the door panel.


Sorry, no pictures.

Danthurs speaks the truth. If you need pictures a Haynes repair manual comes in handy. You may also need to buy some new door panel clips(I always end up breaking at least two). Most auto part stores have them.