Remove the rear manifold on a Transport-3.8L -95
Thread Starter
Junior Member
Posts like a Ricer Type-R
Joined: Mar 2011
Posts: 10
Likes: 0
From: Boras Sweden
Remove the rear manifold on a Transport-3.8L -95
Need to remove the rear exhaust manifold on a 3.8L -95 Pontiac Transport.
Obviously it is impossible, however my thoughts was to lower the rear of the frame, to get some more space.
Now is it "just" to disconnect the steering column and loosen those two rear bolts (left and right side), support it with a jack and lower it some 50-100mm, or is there something else to think of?
Obviously it is impossible, however my thoughts was to lower the rear of the frame, to get some more space.
Now is it "just" to disconnect the steering column and loosen those two rear bolts (left and right side), support it with a jack and lower it some 50-100mm, or is there something else to think of?
Member
Posts like a V-Tak
Joined: Sep 2010
Posts: 90
Likes: 3
Not knowing the bay of the transport, is it possible to remove the front dogbone(*) and rock the motor forward at all?
Barring that, lowering the subframe you would have to be sure that none of the PS lines were hanging up and any electrical harnesses that may be attached to it.
Then just lower the subframe and support it well and off you go.
Barring that, lowering the subframe you would have to be sure that none of the PS lines were hanging up and any electrical harnesses that may be attached to it.
Then just lower the subframe and support it well and off you go.
Thread
Thread Starter
Forum
Replies
Last Post
TnT_Tyler
Performance, Brainstorming & Tuning
7
Oct 25, 2006 08:28 PM
Manifest
Lounge
2
Apr 17, 2006 09:10 AM
