Rear door window
Thread Starter
Senior Member
Posts like a Turbo
Joined: Sep 2002
Posts: 260
Likes: 0
From: Nj/Pa
Rear door window
My pwr window motor on my rear door took a crap! No warning at all!
Does anyone know if this is a hard job to do? I know rivets have to be drilled out--but anything harder then that to do the job?
I also noticed there were some small bolts bolting the lower housing to the upper housing on the motor itself--would I be able to just unbolt those 4 bolts and bolt the motor guts to the old housing instead of swapping the whole deal?
Does anyone know if this is a hard job to do? I know rivets have to be drilled out--but anything harder then that to do the job?
I also noticed there were some small bolts bolting the lower housing to the upper housing on the motor itself--would I be able to just unbolt those 4 bolts and bolt the motor guts to the old housing instead of swapping the whole deal?
Thread
Thread Starter
Forum
Replies
Last Post
mikeblue94
Everything Electrical & Electronic
1
May 3, 2004 04:47 PM