Quick PCM question
#1
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Quick PCM question
Ordered my new PCM from Intense last night, shoudl have it in a few days. I assume to change it I simply remove the old one, and connect the new one. And that'* it? I have a 97 so it'* my understanding I will not have to worry about a case learn.
I will also be going in Wednesday to get a new 80 series muffler. Going to be a good week.
I will also be going in Wednesday to get a new 80 series muffler. Going to be a good week.
#5
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
I have a stock valve train. Will I be OK with 6000rpm shift points? I do plan to upgrade my springs, but for now will I bo OK. I see red line on the tach is 6000 and I assume this is set lower then it really is. Thanks.
#6
Senior Member
Certified Car Nut
Join Date: Oct 2003
Posts: 19,756
Likes: 0
Received 0 Likes
on
0 Posts
REMEMBER!!!
you need to remove your knock module (the square cover with the allen head screws) from the OLD PCM and switch it over to the INTENSE PCM. If you do this you dont need a case learn done
you need to remove your knock module (the square cover with the allen head screws) from the OLD PCM and switch it over to the INTENSE PCM. If you do this you dont need a case learn done
Thread
Thread Starter
Forum
Replies
Last Post
zigmeisterxiv
1992-1999
1
02-10-2010 07:42 PM