Uim
#1
Senior Member
Posts like a Turbo
Thread Starter
Uim
I think it might be going again, just had it done about 30k ago. I see a small pool of what looks to be coolant on the back of the engine pooling up in the molding on top. I don't have any money left in the budget to get it fixed. It is common to have it go that quick? Suggestions?
#2
Senior Member
True Car Nut
Join Date: Jan 2009
Location: Dover, NH
Posts: 7,122
Likes: 0
Received 0 Likes
on
0 Posts
the UIM on the Ei is just a paper gasket between the blower and the LIM so not thinking it'* that. your LIMs sound like the culprit. when you replaced them did you use the fel- pro perma seals or the nice thick GM updated ones? i have seen the perma seal ones and am not really impressed with them.
#4
Senior Member
True Car Nut
Join Date: Jan 2009
Location: Dover, NH
Posts: 7,122
Likes: 0
Received 0 Likes
on
0 Posts
it shouldn't need the LIMs if it was done by the dealer, however it also depends on if they used the updated gaskets. when did they do the service ( month / year)?
also another culprit to check out is the coolant elbows. those things like to fail like crazy
also another culprit to check out is the coolant elbows. those things like to fail like crazy
#5
Senior Member
Posts like a Turbo
Thread Starter
Were are the elbows located? I would say it was done about 5 years ago. Not sure exactly on the month.
#6
Senior Member
True Car Nut
Join Date: Jan 2009
Location: Dover, NH
Posts: 7,122
Likes: 0
Received 0 Likes
on
0 Posts
the elbows are located on the alternator bracket. while that is off changing the valve cover gaskets is a good idea since you have to remover the bracket to get the rear valve cover off
#7
Senior Member
Posts like a Turbo
Thread Starter
Yea Ill take a look there and see maybe if it is dripping at all and maybe burning up. Looks like if that isn't the case Id have to shell out the money to get it fixed :(
#8
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Where exactly is it pooling up? Passenger side, drivers side, front, back. On the drivers side it'* likely the throttle body gasket. Passenger side, it'* likely the elbow. When the LIM gaskets fails, it will not leak to the outside. Instead it seeps in to the lifter valley.