Trans Brake or two step?
This is kinda out there but, can a 4T65E be programmed for a trans brake?
and
How about a two step then to go with the trans brake?
A transbrake is a device which allows a car to remain stationary even when the motor is under power. It works by placing the transmission in 1st gear and Reverse at the same time. Since both gears have the same ratio, but it opposite directions, the car cannot move. The transbrake can be released with a button, which releases the Reverse gear.
How about a two step then to go with the trans brake?
A two-step is an electrical ignition device that will "cut out" cylinders at random, after the engine rpm tries to exceed a certain point. This is basically a rev-limiter. The driver can set the low-side rpm of the two-step to be his launch rpm. With this, the driver can activate the two-step, and press the gas to the floor without over-revving the engine. You can recognize a two-step by the uneven Pop-Pop-Pop of the motor. Release the two-step, and the motor is unleashed, the throttle already wide open.
http://www.gm.com/company/gmtunersou...build_book.pdf
on page 107 of the pdf.
And trhe thread i got it from is:
http://www.clubgp.com/newforum/tm.as...de=&*=#2252490
on page 107 of the pdf.
And trhe thread i got it from is:
http://www.clubgp.com/newforum/tm.as...de=&*=#2252490
Originally Posted by 95naSTA
http://www.gm.com/company/gmtunersource/downloads/gm_sport_compact_performance_build_book.pdf
on page 107 of the pdf.
And trhe thread i got it from is:
http://www.clubgp.com/newforum/tm.as...de=&*=#2252490
on page 107 of the pdf.
And trhe thread i got it from is:
http://www.clubgp.com/newforum/tm.as...de=&*=#2252490
Trans brake not required below 800hp
Thread
Thread Starter
Forum
Replies
Last Post
two bonnies
1992-1999
9
Feb 9, 2007 11:19 AM
harofreak00
Your Ride: GM Pictures & Videos
0
Nov 11, 2006 09:54 PM
ga93sle
Your Ride: GM Pictures & Videos
16
Dec 8, 2005 09:54 PM
killer_cr80r
Lounge
8
Apr 3, 2004 07:16 PM
evilsaint
1992-1999
2
Oct 22, 2003 01:09 AM




