SS M90 Swap
Thread Starter
Senior Member
Posts like a Corvette
Joined: Jun 2008
Posts: 1,389
Likes: 0
From: Cleveland, OH

I am going to be doing an SS M90 SC swap soon, it was used on a friend of mines buick regal until it was totalled so I have all the parts, anything weird I might find putting it on the bonni?
Thread Starter
Senior Member
Posts like a Corvette
Joined: Jun 2008
Posts: 1,389
Likes: 0
From: Cleveland, OH

It is from a 97 GP I'm pretty sure, it has the connection for the brake booster, then 2 others, 1 is used for the boost bypass valve and the other was for a vacuum line that went to the climate control, I think I can just block off the other connector beacuse there is a seperate tree with 2 connectors that you just run a piece of line to each
Thread Starter
Senior Member
Posts like a Corvette
Joined: Jun 2008
Posts: 1,389
Likes: 0
From: Cleveland, OH

also what bin should I use from a stock SC car? I know I have to pull out some timing per the ZZP instructions, and put my tranny settings into the new bin, anything else?
Thread Starter
Senior Member
Posts like a Corvette
Joined: Jun 2008
Posts: 1,389
Likes: 0
From: Cleveland, OH

Well I will use a SSEi bin then make the changes that ZZP calls for, like taking 8 degrees of timing out throught the tables, and AE fuel ratio, and PE I think, its all in the directions, then put my MAF and trans tables in from my bin since I will use the same TB and trans
Thread
Thread Starter
Forum
Replies
Last Post
SPEED ADICTIONS
Performance, Brainstorming & Tuning
3
May 5, 2008 09:52 PM






