Relocation PCM in '96
#1
Senior Member
Posts like a Corvette
Thread Starter
Join Date: Jul 2004
Location: Winnipeg, Manitoba, Canada
Posts: 1,445
Likes: 0
Received 0 Likes
on
0 Posts
Relocation PCM in '96
I'm about to put the CAI from the '89 in the '96. What should I do about the PCM? Should I just try to go around it? I mean, I could just have it under the intake but it wouldn't be secured down...is that unsafe? The PCM tray from intense doesn't work on the '96 either, so I'm running out of ideas.
Also, whats that aluminum stuff you guys all make heat shields out of? Where do you get it?
ty
Also, whats that aluminum stuff you guys all make heat shields out of? Where do you get it?
ty
#3
Senior Member
Posts like a Camaro
Join Date: Jun 2005
Location: n.h.
Posts: 1,066
Likes: 0
Received 0 Likes
on
0 Posts
you could get a 97+ PCM box and it will hold just like the factory. CFoote just did the 97+ PCM box upgrade this weekend and it bolted in with no problems
#4
DINOSAURUS BOOSTUS
Expert Gearhead
I'd suggest a 97 pcm cover. It actually is only held in with a couple of plastic push pins. Very easy to install, leaves your pcm in almost the same location (slightly closer to fender and gets that silly wing off your pcm cover.
Thread
Thread Starter
Forum
Replies
Last Post
tpulliam79
Performance, Brainstorming & Tuning
6
05-10-2008 06:55 PM