Motor swap & upgrades IT"S ALIVE!!!
#13
Senior Member
True Car Nut
Thread Starter
Join Date: Aug 2005
Posts: 5,798
Likes: 0
Received 0 Likes
on
0 Posts
i got a little update:
bothe mannys are welded and ported, and waiting for some type of coating
and i POLISHED my LIM and painted it
And i paintd the accessory bracket
bothe mannys are welded and ported, and waiting for some type of coating
and i POLISHED my LIM and painted it
And i paintd the accessory bracket
#15
Junior Member
Posts like a Ricer Type-R
In this pic:
Replace the plastic coolant fitting with a steel one from the dealer, or if it'* already steel, clean the paint off.
Polish the paint out of the injector bosses also. You want your o-rings to contact aluminum, not paint.
Looking good! I envy your accessory bracket.
Replace the plastic coolant fitting with a steel one from the dealer, or if it'* already steel, clean the paint off.
Polish the paint out of the injector bosses also. You want your o-rings to contact aluminum, not paint.
Looking good! I envy your accessory bracket.
#16
Senior Member
True Car Nut
Thread Starter
Join Date: Aug 2005
Posts: 5,798
Likes: 0
Received 0 Likes
on
0 Posts
yeah its steel, i was going to tap it off but ended up no because i looked as if it had black paint on it from before so i figured it didnt matter, but ill get it all off there. as for the injector holes i knew that but it would have been a bitch to mask so i figured id just paint and clean after.
#20
Senior Member
True Car Nut
Thread Starter
Join Date: Aug 2005
Posts: 5,798
Likes: 0
Received 0 Likes
on
0 Posts