Modification Advice for a '93 Park Avenue

Reply Subscribe

Thread Tools

Search this Thread

Nov 5, 2004 | 03:01 AM

Krazy Kyle

Thread Starter

Senior Member

Posts like a Corvette

Joined: Nov 2003

Posts: 1,534

Likes: 0

From: Brunswick, Georgia, USA, North American Continent, Earth, Milky Way Galaxy

Modification Advice for a '93 Park Avenue

Any advice? Just looking into minor performance, appearence, etc. stuff, nothing extensive. Well? thanks again, guys

Nov 5, 2004 | 09:33 AM

95naSTA

Senior Member

True Car Nut

Joined: Feb 2003

Posts: 4,508

Likes: 2

From: Philly

Civic intake with homemade heat shield, 180 thermostat, highflow cat???
That should give you some ponies.

Nov 5, 2004 | 10:57 AM

Krazy Kyle

Thread Starter

Senior Member

Posts like a Corvette

Joined: Nov 2003

Posts: 1,534

Likes: 0

From: Brunswick, Georgia, USA, North American Continent, Earth, Milky Way Galaxy

Hehehe, sounds a bit extensive (and expensive) to me

Nov 5, 2004 | 11:04 AM

opensourceguy

Senior Member

True Car Nut

Joined: Apr 2004

Posts: 4,879

Likes: 6

From: Three Oaks, Michigan

opensourceguy is on a distinguished road

that'* not even expensive to me, and I never have any money. $100 for intake[AND heatsheild], $50 for cat, $5 for the tstat. If the cat was shot, and the air filter was clogged, this will give you quite an increase.. perhaps 20 ish??

-justin

Nov 5, 2004 | 11:08 AM

Krazy Kyle

Thread Starter

Senior Member

Posts like a Corvette

Joined: Nov 2003

Posts: 1,534

Likes: 0

From: Brunswick, Georgia, USA, North American Continent, Earth, Milky Way Galaxy

But what about the HOMEMADE heat shield? Homemade is not a good word for me...

Nov 5, 2004 | 11:23 AM

opensourceguy

Senior Member

True Car Nut

Joined: Apr 2004

Posts: 4,879

Likes: 6

From: Three Oaks, Michigan

edited for the picky bastards.

you can just use tin foil wrapped around the air filter element, held on with some duct tape.. however an arcylic box like Bill has.. would cost $10-$20 more I believe.

-justin