I'm new here!
Senior Member
Posts like a Northstar
Joined: Apr 2009
Posts: 699
Likes: 0
From: Indianapolis, Indiana
Hey its never too late. And yes welcome to the forum. Seems a little strange that they would make shocks for this thing that required more pressure than the factory compressor could put out. Where did you get the shocks from?
Thread Starter
Junior Member
Joined: Dec 2010
Posts: 5
Likes: 0
From: Tualatin Oregon
I got the shocks from a GM parts distributor and they are listed as a superseded part.
There is a couple paper that came with the shocks one says if there are any problems look for leaks in the system. I did that and referenced the service manual too. I made a tester to check each shock individually, no leaksin them pulled the compressor and checked the accumulator, it was fine.
The other sheet said this set of shocks has a requires a minimum of 25 lbs pressure and max of 200 lbs.
Sort of odd for a system that is set for 7-14 lbs as its minimum residual pressue.
If there was a check valve to install to maintain the higher minimum I would understand the use of these shocks but nothing else was indicated.
To resolve the issue I went ahead and had the shocks changed out to the Monroe MA822 part number units.
I am going to voice my disappointment to the parts placebubt am otherwise screwed.
I work at a Community college in the auto dept. and had students do the work, they tossed the box before I figured there was a problem so returning them will only be if the supplier will take them.
Oh well I will use them for a classroom training aid and make an air ride suspension unit,so it goes.
Thanks for the interest at least there was a sounding board.
There is a couple paper that came with the shocks one says if there are any problems look for leaks in the system. I did that and referenced the service manual too. I made a tester to check each shock individually, no leaksin them pulled the compressor and checked the accumulator, it was fine.
The other sheet said this set of shocks has a requires a minimum of 25 lbs pressure and max of 200 lbs.
Sort of odd for a system that is set for 7-14 lbs as its minimum residual pressue.
If there was a check valve to install to maintain the higher minimum I would understand the use of these shocks but nothing else was indicated.
To resolve the issue I went ahead and had the shocks changed out to the Monroe MA822 part number units.
I am going to voice my disappointment to the parts placebubt am otherwise screwed.
I work at a Community college in the auto dept. and had students do the work, they tossed the box before I figured there was a problem so returning them will only be if the supplier will take them.
Oh well I will use them for a classroom training aid and make an air ride suspension unit,so it goes.
Thanks for the interest at least there was a sounding board.
Senior Member
Certified GM nut
Joined: Dec 2005
Posts: 1,916
Likes: 0
From: dekalb illinois
welcome to the club, nice rig!
id love to see a video of how you get those ATV'* up there
i love the color of your dually..then again im kinda partial to the color even though its a shade or two off (see siggy)
id love to see a video of how you get those ATV'* up there
i love the color of your dually..then again im kinda partial to the color even though its a shade or two off (see siggy)
Thread
Thread Starter
Forum
Replies
Last Post
chambiec1
Introductions for new members
20
Aug 29, 2007 09:34 PM
Bonneville92V688
Lounge
47
Aug 24, 2007 05:09 PM
