power steering not working
#1
Senior Member
Posts like a 4 Banger
Thread Starter
power steering not working
i have a 1989 gmc r3500 with a 454 that when its below 1000 rpms the power steering doesn't work but as soon as you rev it it works.its hydro boost if that helps any.the pump also runs the brakes and as far as i can tell they work fine.should i replace the pump or look elsewhere
#3
Senior Member
Posts like a 4 Banger
Thread Starter
#4
Retired
You didn't even answer his question.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#5
Senior Member
Posts like a 4 Banger
Thread Starter
#6
Senior Member
There'* a spool valve that opens for the assist and they sometimes will get gunky and not open as they should.
Make sure the vacuum side is hooked up properly and not leaking. Check the vacuum tank and make sure it holds.
Do you have a way to check pressures?
Make sure the vacuum side is hooked up properly and not leaking. Check the vacuum tank and make sure it holds.
Do you have a way to check pressures?
#7
Senior Member
Posts like a 4 Banger
Thread Starter
do you think i should try a flush and new pump?i dont know if it matters but pump was a re manufactured pump.and i should have a way to check.and truck has no vac leaks.there isnt any vac lines on a hydroboost is there?
#8
Senior Member
True Car Nut
#10
Senior Member
True Car Nut
Might be a bad pump or bad hydroboost. The hydroboost gets pressure first, then allows residual pressure to pass to the steering gear. Could be something gummed up in the hydroboost.
What did the original pump do when it failed?
What did the original pump do when it failed?