power door locks dont work
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: May 2005
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
power door locks dont work
yea i was gonna see if ne one had this happen to them my power door locks and intior lights and power antenna doenst work its a fuse its supposed to be a 15 amp fuse and it blows them i put a 20 in and it blew i dont wanna do it ne more cause i wanna keep my car lol if u no wat it is please contact me or reply to this thank you..
#2
check the fuses under the dash on the paassenger side where they rest there feet at, pull that black cover off and check the fuses there. if you have an owners manual, it will help you locate the fuses
#3
Junior Member
Posts like a Ricer Type-R
Steve, he just said his fuse BLOWS when he puts it in. He knows where it is, and he has the right one.
92se, you need to disconnect everything in that circuit, replace the fuse, then start connecting components until the fuse blows to find the short.
92se, you need to disconnect everything in that circuit, replace the fuse, then start connecting components until the fuse blows to find the short.
#4
DINOSAURUS BOOSTUS
Expert Gearhead
Originally Posted by willwren
Steve, he just said his fuse BLOWS when he puts it in. He knows where it is, and he has the right one.
92se, you need to disconnect everything in that circuit, replace the fuse, then start connecting components until the fuse blows to find the short.
92se, you need to disconnect everything in that circuit, replace the fuse, then start connecting components until the fuse blows to find the short.
#5
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: May 2005
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
yea i totally unplugged my antanna so i know its not that and thers not corrosion i think its just a messed up ground.. or a bad wire somwere ...
#7
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: May 2005
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
found it!!
i found it but didnt fix it its gonna take major work... i looked at the wiring going into the fuse box... yea there are like 3 wires that are melted showing bear wires... not good... soo im gonan say scew it i can do it the old fashion way- by hand
Thread
Thread Starter
Forum
Replies
Last Post
stillkickin
Everything Electrical & Electronic
4
08-21-2011 07:33 PM
anthonyv62
Everything Electrical & Electronic
2
01-19-2004 02:27 PM