Chevrolet When starting new posts, please specify YEAR, MAKE, MODEL, ENGINE type, and whatever modifications you have made.

traverse 2010 reduce engine power !

Thread Tools
 
Search this Thread
 
Old Jan 25, 2015 | 08:33 AM
  #1  
Holden's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Dec 2014
Posts: 62
Likes: 6
Holden is on a distinguished road
Default traverse 2010 reduce engine power !

hi all ,,,

I am working on chevy traverse 2010 .. 100,000 KM only .


the problem is reduce power engine ! white smoke ! smell a gas !

I put my scanner and there is codes :

p2178 system too rich

p0087 fuel rail regulator and p0089 ( low and high pressure codes )

random misfire AND CYLNDER1 and 2 a high misfire detected p0301 and p0305 and one code for injection 1 leaking p029D ,, the car is too heavy and poor fuel economy

I just replace the spark plugs ..

any help ! Ijust stop the car now
Reply
Old Jan 25, 2015 | 11:21 AM
  #2  
Tech II's Avatar
Senior Member

True Car Nut
 
Joined: Feb 2014
Posts: 2,878
Likes: 1,097
From: Worcester, Ma.
Tech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond repute
Default

Well, if you have been driving the vehicle this way for a long time, you could have created other problems....just guessing, but the fact that you have an injector problem and misfire problem on the same cylinder, could either be an injector or injector circuit problem......

If you have run the vehicle this way for a long time, that rich condition could have contaminated the pre O2 sensor......need to check the fuel pressure too, which could be affected by a bad injector or f/p regulator.....
Reply
Old Jan 25, 2015 | 12:11 PM
  #3  
Holden's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Dec 2014
Posts: 62
Likes: 6
Holden is on a distinguished road
Default

Thanx tech II

I just bought new fuel pressure regulator , tomorrow i will change it and come here again .

U tell me that the problem From the long millage ? It just 100 K not mile .

Q: does the regulator make the car going in rich system ! Cause my fuel is going out from the rear exhaust !
Reply
Old Jan 25, 2015 | 12:17 PM
  #4  
Tech II's Avatar
Senior Member

True Car Nut
 
Joined: Feb 2014
Posts: 2,878
Likes: 1,097
From: Worcester, Ma.
Tech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond repute
Default

Well, you will have unburned fuel, if you have a misfire......and you have possible injector/circuit problems.....even possible MAF/O2 problems?

Even at 66K miles, things can happen,.......
Reply
Old Jan 25, 2015 | 12:20 PM
  #5  
Holden's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Dec 2014
Posts: 62
Likes: 6
Holden is on a distinguished road
Default

So start with what ?

Also there is no code in maf or o2 .. Only misfire is 2 cylinder 1 and 5

And 1 injector code ( cyl 1 )

So we hope to share this issue for all members .. Thanx alot
Reply
Old Jan 25, 2015 | 02:17 PM
  #6  
chevy82's Avatar
Senior Member
Posts like a Turbo
 
Joined: Jan 2014
Posts: 396
Likes: 101
From: Missouri
chevy82 is a glorious beacon of lightchevy82 is a glorious beacon of lightchevy82 is a glorious beacon of lightchevy82 is a glorious beacon of lightchevy82 is a glorious beacon of lightchevy82 is a glorious beacon of light
Default

Very good possibility you have a bad injector. These 3.6s are known for injectors to fail and ignition coils. To verify a bad injector a Active fuel injector tester (Dealer item) is needed to test the injector output.
Reply
Old Feb 6, 2015 | 03:15 PM
  #7  
Holden's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Dec 2014
Posts: 62
Likes: 6
Holden is on a distinguished road
Default

UPDATE 6:: feb

I was working on problem and i found 3 injection are ( bad ) .. So we change the three injections .

Clean the regulator .. Check all coils .. Spark plugs

Problem is solved for 5 min then reduce engine power again !!!

I check the oil dipstick and there us smell fuel and i guess the is fuel on !!

There is white smoke rear .. Smell gas .. Don know what to do know ?
Reply
Old Feb 6, 2015 | 03:44 PM
  #8  
Tech II's Avatar
Senior Member

True Car Nut
 
Joined: Feb 2014
Posts: 2,878
Likes: 1,097
From: Worcester, Ma.
Tech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond repute
Default

How did you determine that 3 injectors were bad?
Reply
Old Feb 6, 2015 | 03:56 PM
  #9  
Holden's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Dec 2014
Posts: 62
Likes: 6
Holden is on a distinguished road
Default

We remove it in machine .. It is bad .. And also the seal is bad
Reply
Old Feb 6, 2015 | 04:05 PM
  #10  
Tech II's Avatar
Senior Member

True Car Nut
 
Joined: Feb 2014
Posts: 2,878
Likes: 1,097
From: Worcester, Ma.
Tech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond reputeTech II has a reputation beyond repute
Default

Originally Posted by Holden
We remove it in machine .. It is bad .. And also the seal is bad
Not sure what "remove it in machine....It is bad", means.....
Reply



All times are GMT -4. The time now is 04:26 AM.