Slave clutch cylinder
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Slave clutch cylinder
hello again
another question, where is the slave clutch cylinder i think i have air in the line cuz the clutch doesnt engage until i press it all the way down. reservoir was empty so maybe there is a leak but no sure yet
thank you
95 cavalier 2.2 base
another question, where is the slave clutch cylinder i think i have air in the line cuz the clutch doesnt engage until i press it all the way down. reservoir was empty so maybe there is a leak but no sure yet
thank you
95 cavalier 2.2 base
#2
Senior Member
the clutch doesnt engage until i press it all the way down.
Really? You must really have to ride the clutch, then, don't ya?
If you have no fluid in the reservoir, you obviously have a leak....if no external leak found, then it'* in the transmission, like maybe the clutch actuator cylinder.....I would check to see if there is fluid in the housing....if there is, your clutch disc is probably contaminated and slipping, too....
You must know where the slave cylinder is if you know where the reservoir is....just follow the tube out of the bottom of the reservoir....
The following users liked this post:
Soft Ride (03-24-2018)
Thread
Thread Starter
Forum
Replies
Last Post
Spiral
General GM Chat
4
04-16-2004 04:32 PM