1995 Buick Lesabre Limited 3.8L v6 firewall passthrough
#1
1995 Buick Lesabre Limited 3.8L v6 firewall passthrough
In the midst of installing an Amp and Sub to my 95 lesabre I wired the power under the door trim and all but am now stuck in the passenger side of the cabin and cannot locate an area where I can pass a 4G wire through to the engine to hook it up to the battery. Battery is on the passenger side. Would like to avoid drilling holes if I can
#2
Senior Member
I would drill a hole, wherever it is convenient....makes the hole big enough, so that a rubber grommet will fit tightly around the wire, so that the wire is protected from chafing, and the grommet will act as a good weather seal....and make sure the power source is protected with a fuse.....
The following users liked this post:
WilliamE (05-07-2017)
#4
Senior Member
True Car Nut
In the midst of installing an Amp and Sub to my 95 lesabre I wired the power under the door trim and all but am now stuck in the passenger side of the cabin and cannot locate an area where I can pass a 4G wire through to the engine to hook it up to the battery. Battery is on the passenger side. Would like to avoid drilling holes if I can
I would drill a hole, wherever it is convenient....makes the hole big enough, so that a rubber grommet will fit tightly around the wire, so that the wire is protected from chafing, and the grommet will act as a good weather seal....and make sure the power source is protected with a fuse.....
#5
Senior Member
Yes it seems wnlewis is also having the tool/pin discussion post # 25 currently in this thread: https://www.gmforum.com/buick-172/no...-312366/page3/
This Thread I will Close Then.
This Thread I will Close Then.
__________________
1997 Buick Pk Ave (Soft Ride) Suspension!
1997 Buick Pk Ave (Soft Ride) Suspension!
Thread
Thread Starter
Forum
Replies
Last Post
2004buicklesabre
Audio (and aftermarket electronics)
3
01-05-2011 04:10 PM