Trunk rattle/Deadening material
#1
Trunk rattle/Deadening material
I was wondering if any of you guys have put Dynamat or any of the other products in your trunk for deaden the rattles and how much ft² you used to get it completed.
#2
Senior Member
Posts like a Turbo
Join Date: Dec 2006
Location: Cincinnati, Ohio
Posts: 484
Likes: 0
Received 0 Likes
on
0 Posts
its been so long since I have ordered my sound deadner that, I dont remember how much I ordered. Its even tougher because you are going to want to do maybe 2-3 layers. where are you getting it from? maybe they are used to selling it to alot of different sized cars and can make the best suggestion to you. I do remember when i got my sound deadner from elemental designs, I just told the guy I drove a bonnie and he said well that has a large trunk so you would probably need x amount. Look on the bright side, if you end up with more, you can always use it in areas that need it the most where as to ending up with less and not having enough
#4
I guess I can stop being lazy and get out there a measure it and figure it all out. I was going to try peel and seal or e-dead. I figure either one will work good enough,
#5
Senior Member
Posts like a Turbo
Join Date: Dec 2006
Location: Cincinnati, Ohio
Posts: 484
Likes: 0
Received 0 Likes
on
0 Posts
e dead is great. you should order the thickest mil they have. order enough to do a few layers. especially on the trunk lid so it doesnt rattle. and license plate
Thread
Thread Starter
Forum
Replies
Last Post