anyone know a good site where i can go to look at wiring diagram to hook up a remote start, i have one already installed but recently when i start it the starter doesn't disengage, i have a rs7k2 remote start if that matters any.

Do you have a manufacturer name like Viper or Clifford?

Does the starter disengage normally if you start the car with out the remote starter? If so I would suspect the remote starter unit as defective.

omega rs7ks and yes the starter disengages when i dont use the remote start, i found a site a while ago that had the wiring diagram for it but now i cant find it.

The start feature is usually controlled by the brain unit of the remote and it sounds like it either can't see the tachometer signal or there is a deeper issue in the circuitry.

Although I was under the impression that it was supposed to run the starter for a moment or two, then check the signal. Retry if a no start occurred.

Good description and I agree with the tach sense. Maybe came disconnected or the unit lost the programmed idle speed. I'v seen this happen with other remote starters after jump starting. It appears as if you need the installation/programming manual for the remote start. Have you tried the manufacturer'* website to see if you can download the manual? If it'* not available, www.the12volt.com forum would be the second best place to look. First look in the "downloads" section then in the Security forum.

A good one is bulldogsecurity.com Thats where I got mine

A good one is bulldogsecurity.com Thats where I got mine

it started acting different when it got cold out, the starter will disengage after about 5 seconds and then its fine, i just dont want screw up the starter. and that was the site where i got before just couldnt remember it

Hi I can’t find my wires for bulldog remote starter, like domelight, and factory alarm disarm.
I have a Bonneville '92SE.
Any help appreciated.

90% if the wires will be contained in the colum