I know this isn't the best set up but most of it was a gift and it'* not that bad for a first system I suppose. I have no idea what size wiring and everything else that I need to install the stuff below. Also, will I need more power or am I okay with my current battery?

Subs are:
Model Description...........................BTL10X3 10" Tri-Sub Enclosure
Impedance.....................................4 ohm
Power (W) RMS/Total....................750/1500
Frequency Response....................43Hz - 150Hz
Sens.............................................. .92.2dB
Dimensions (H x W x D)................ 13 1/4" x 35 1/4" x 14 1/2"


Amp is:
Audiobahn A8002T
RMS Power: 200W x 2
Bridged RMS Power: 800W x 1
THD at Rated RMS Power: 0.02%
Speaker Level Inputs: No
Preamp Outputs: Yes
Built-In Crossovers: HP/LP
Bass Boost: 0-18 dB
Frequency Response: 10-40,000 Hz
Channel Separation: n/a
Signal to Noise Ratio: > 100 dB
Fuse Rating: n/a

to keep it simple, look for a 4 gauge amplifier wiring kit. ittl have everything you need for that setup. check out knukonceptz, stinger, rockford fosgate and streetwires. im pretty sure they all sell such kits

you wont need to upgrade anything on the car either

Ok. Thanks.

www.knukonceptz.com

atleast 60 dollars cheaper than the other brands mentioned.