ok im retarded and dont know a whole lot bout modding and ****.. ok..so dont laugh to hard...is the t-stat simple to do??

Yes, try doing a search. It'* very easy to do.

Wait until the engine is cold. Undo the 2 10mm bolts holding the tstat housing on. Take off the housing remove the tstat. Put the rubber ring seal (a new one) around the new tstat and replace it, the housing and the 2 10mm bolts. Tighten 11 ft/lbs. Make sure no coolant is left in the bolt holes or your torque settings will be off and you will probably leak.

ur car is freakin awsome! heh any way....for intake question, i see u have a cold air customer, is that silver square the one in our stock air system...the middle black box??? if so is that easy to take out?? and... where can i put it once out of the black box??

thanks man for the t-stat info. im new to the engine modding.

The silver box is the Powertrain Control Module. It'* what runs the engine. Stock, it is sitting in the airbox and just lifts out. I have mine mounted in the corner where the stock airbox was. It'* held down with double sided molding tape.

ok ill try to leave u alone after this does auto zone have that hose the the intake.. im guessin it something special... how long is it?!?!

You can buy it from INTENSE.

http://www.intense-racing.com/Mercha...tegory_Code=IF

Its the 3.5 Diameter and 3 feet will do you. I actually used 2.5 but not sure they sell by the half foot.