trouble code P0640
10-02-2004, 04:03 PM
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Sep 2004
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
trouble code P0640
95 Bonny. ECC temp numbers are blinking. Hooked up a scan tool and its showing this.
History Code Module
Quad Driver Module
QDM 1 fault.
a/c blows cold after about a minute of the blinking #'*. before that, is warm. Freon is charged good.
Any help?
History Code Module
Quad Driver Module
QDM 1 fault.
a/c blows cold after about a minute of the blinking #'*. before that, is warm. Freon is charged good.
Any help?
10-02-2004, 05:14 PM
#2
Junior Member
Posts like a Ricer Type-R
You cannot pull ECC codes through the ALDL connector. Only the dealer can extract ECC codes from 94 and up.
Your QDM fault isn't related to climate control. Do a search on QDM 1 or QDM A and you'll find your list of possibilities.
Moving to 92-99
Your QDM fault isn't related to climate control. Do a search on QDM 1 or QDM A and you'll find your list of possibilities.
Moving to 92-99
10-02-2004, 06:24 PM
#6
Junior Member
Posts like a Ricer Type-R
26- Quad Driver A module monitors the low speed fan, Evap canister purge solonoid, the HIGH TEMP light, and TCC apply. Note that it does NOT monitor the high speed fan relay. Only the low speed is considered critical?
Quad B covers the shift solonoids and EGR valve.
What are your Rpm'* at 55 mph?
Quad B covers the shift solonoids and EGR valve.
What are your Rpm'* at 55 mph?
10-04-2004, 04:27 PM
#8
Junior Member
Posts like a Ricer Type-R
Originally Posted by jal0065
RPM'* at 55mph is 1600-1700.
26- Quad Driver A module monitors the low speed fan, Evap canister purge solonoid, the HIGH TEMP light, and TCC apply. Note that it does NOT monitor the high speed fan relay.
Disconnect your battery for 30 minutes to clear the code, go drive for 30 minutes, come back and pull codes again.
10-06-2004, 07:18 PM
#9
Member
Posts like a V-Tak
Thread Starter
Join Date: Sep 2004
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
my friend is bringing his scanner today and I will clear the code. By the way I do not have a check engine light on. I had that code pull by autozone. I wonder if it was one of those scanner that will give you a false reading. I read this on another post.