supercharger pulley assembly for 97 Bonneville
#1
Junior Member
Thread Starter
Join Date: Jun 2007
Location: Joliet, IL
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
supercharger pulley assembly for 97 Bonneville
I just bought a junkyard engine and trans from a 97 GTP, and see that the engine mounts are different. I used the original bonneville mounts, but the pulleys from the GTP don't work with the mount. Is part number 10564505 the right pulley assembly to use? Can I use the existing lower pulley for this set up (the one that is right up against the motor mount)?
Thanks, Al
Thanks, Al
#4
i have done the swap of a 98 gtp to a 00 ssei, but your swap is different cuz of the torque axis mount. i dont have much experience with that, so I will let someone else answer
however, what i do know is that along with the engine and transmission, you are going to need the wiring harnesses and PCM
however, what i do know is that along with the engine and transmission, you are going to need the wiring harnesses and PCM
#5
Junior Member
Thread Starter
Join Date: Jun 2007
Location: Joliet, IL
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
I have the PCM and the harness, but the harness on a GTP goes to a fuse box on the wheelwell, not to the firewall like my Bonneville. However, I have compared the harnesses and I believe I can modify my harness (trans plug, bcs, fuel pump, map, evac). I just don't know what tool to buy to fit the wires into the computer pcm connectors.
Thread
Thread Starter
Forum
Replies
Last Post
Allmachtige
1992-1999
1
10-05-2006 08:31 PM
Mr Bean
1992-1999
9
02-19-2003 11:34 PM