Stuck lifter?
#11
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
The chances of the lifter wearing out the cam lobe is very small, unless the roller seized up.
Check your harmonic balancer. If that'* messed up you will get vibrations. There'* a rubber area between the inside and outside, if that rubber goes bad it will vibrate.
Check your harmonic balancer. If that'* messed up you will get vibrations. There'* a rubber area between the inside and outside, if that rubber goes bad it will vibrate.
#12
Senior Member
True Car Nut
Thread Starter
Join Date: Jun 2007
Location: New Lenox, IL
Posts: 2,478
Likes: 0
Received 0 Likes
on
0 Posts
I still need to explain the noise that'* coming out of my engine while revving above 2000 rpm though. I think I'll replace the lifters and then go from there.
#13
One thing I have seen with roller lifters (in 2.5 GM eng) is that the lifter can get turned
sideways, and the roller wont spin anymore, but will eat the cam lobe. Not sure about
a 3800 doing that.
sideways, and the roller wont spin anymore, but will eat the cam lobe. Not sure about
a 3800 doing that.
#14
Senior Member
True Car Nut
Thread Starter
Join Date: Jun 2007
Location: New Lenox, IL
Posts: 2,478
Likes: 0
Received 0 Likes
on
0 Posts
IIRC, 3800'* have lifter guides that prevent them from being installed any other way or from turning on their own.
#16
Senior Member
True Car Nut
Thread Starter
Join Date: Jun 2007
Location: New Lenox, IL
Posts: 2,478
Likes: 0
Received 0 Likes
on
0 Posts
#17
Senior Member
True Car Nut
Thread Starter
Join Date: Jun 2007
Location: New Lenox, IL
Posts: 2,478
Likes: 0
Received 0 Likes
on
0 Posts
I just found this.
The lifters are slotted on two sides.
http://i26.photobucket.com/albums/c1...996_L36_12.jpg
There'* no way they could have turned without breaking the guides. The guides were intact.
The lifters are slotted on two sides.
http://i26.photobucket.com/albums/c1...996_L36_12.jpg
There'* no way they could have turned without breaking the guides. The guides were intact.
#19
Senior Member
True Car Nut
Thread Starter
Join Date: Jun 2007
Location: New Lenox, IL
Posts: 2,478
Likes: 0
Received 0 Likes
on
0 Posts