Hi new member here... We have a 92 bonnie SE which does the following:
check engine light comes on, car makes a "ding, ding, ding", then dies. This happens while slowing down or turning. The car starts right back up after this happens. I just replaced the CKP and TPS, so it'* definately not the crank sensor itself. The codes that the car has are: 22-throttle position sensor circuit (signal voltage low) and 65-cruise servo position sensor circuit.

I know there are other people out there whos bonnies have done the same, so if you could share the fix that would be great!

Thanks in advance

I had a very similar problem to yours and the TPS switch fixed it. Check the condition of the wiring that runs to the TPS? Also, you want to check your fuel pressure? That is part 2 of this problem.

You also might want to look into the Camshaft Position Sensor. That was one of the items I had planned on having replaced before the TPS alleviated the stall out.

Question 1.. You called yourself boost while driving an SE...are you supercharged?

Q2... When you changed the tps etc, did you unhook the battery for about a 1/2 hour? If not give that a try. Crank sensors aren't very common around here.

Nah, It'* a name that has followed me for some time since I raced/built a turbocharged mustang.

Q2... When you changed the tps etc, did you unhook the battery for about a 1/2 hour? If not give that a try. Crank sensors aren't very common around here.[/quote]

Yes the battery has been unhooked.

Ok, from my understanding (never done one) the TPS can be put on wrong. There'* a certain way to put it on. Might be worth checking.

Thinking it starts with a B Jr?

welllllllll.....since ive had ur problem 5 times ima have to go with a fuel pump every time i turned that fuel pump stoped working and shut off the car yea ding ding ding lol i know what ur going threw[/list]

????? Ok, you had a fuel pump go bad once. That'* not grounds to shotgun a problem like this.

A fuel pump failure will be more felt at WOT than at idle.