Removing Harmonic Balancer
#1
Senior Member
Posts like a Northstar
Thread Starter
Removing Harmonic Balancer
Finally got the HB off my 3800 VIN L. Went to hardware store and bought 3 2 1/2 inch-6mm bolts, found good sized washers and bolted them up thru the HB puller. Found the adapter on the thruster bolt to be too big. Wrestled around and found the screw on the installer had a hole thru the center of the bolt. Got the 4 inch push rod that came w/ the installer, inserted it into the puller.......few turns on the ratchet........Wa....La......off came the HB!
Who designed this stupid idea anyway......used to the exterior threaded hole type.
Now to the J-B Weld putty to patch the cracked waterpump bolt hole that cracked while trying to drill out the broken stud on the thing! J-B putty is great stuff.....wait an hour...drill it.....tap it......screw in the bolt.....hope it don't leak.......yep, good stuff.
Who designed this stupid idea anyway......used to the exterior threaded hole type.
Now to the J-B Weld putty to patch the cracked waterpump bolt hole that cracked while trying to drill out the broken stud on the thing! J-B putty is great stuff.....wait an hour...drill it.....tap it......screw in the bolt.....hope it don't leak.......yep, good stuff.
#2
DINOSAURUS BOOSTUS
Expert Gearhead
That design has been around for quite a while. Dunno the name of the guy but he'* old and half dead. You can't go find and beat him down for a design....lol
Thread
Thread Starter
Forum
Replies
Last Post