Screen on MAF Sensor?
11-05-2002, 07:33 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2002
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Screen on MAF Sensor?
I am replacing my MAF Sensor (see recent posting about MAF Sensor problems/ECM Code 34).
While purusing this forum, I saw a few references to "removing the MAF screen".
Is this recommended? If yes, why and what are the potential drawbacks and/or special considerations?
While purusing this forum, I saw a few references to "removing the MAF screen".
Is this recommended? If yes, why and what are the potential drawbacks and/or special considerations?
11-05-2002, 09:26 PM
#2
Senior Member
Certified Car Nut
Join Date: Oct 2002
Posts: 11,308
Likes: 0
Received 0 Likes
on
0 Posts
maf
It'* up to you. With a custom intake it may work better without the screen. Just be careful taking it out. Check "MAF Screen Removal" under "Performance" and you'll find more help.
11-06-2002, 12:53 PM
#3
Senior Member
Certified GM nut
Join Date: Aug 2002
Location: Kalamazoo, MI
Posts: 1,839
Likes: 0
Received 0 Likes
on
0 Posts
Some have had success and some have not. The typical problem is that it creates a poor idle and can sometimes through codes. This happens mostly in Bonnevilles with stock accordian intake tubing, and it is assumed that this tubing is causing air turbulance which gives a false reading from the MAF. If you are changing it anyway, remove the old one, re-assemble, and test drive it for a (short) while. See how it responds. If it runs crappy, put the new on in. If not, than you are one of the few that has a 'macigal intake'. Enjoy!
11-07-2002, 12:50 AM
#6
Junior Member
Thread Starter
Join Date: Nov 2002
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
New MAF Sensor, the screen, and other stuff
Greetings All!
Today I took a leap of faith (on your advice) and replaced my MAF Sensor and cleaned the intakes. I tried to get a NEW AC Delco, but the cheapest I found was about $400. So, I found a remanufactured AC Delco at Advanced Auto (with a lifetime warranty) for $157.00. As it turned-out, it was incredibly simple to do the switch (easier than changing spark plugs) and the car runs sOOOOO much better.
As for the MAF screen, I decided to leave it in because it runs good enough for my purposes. However, when I get around to getting a smooth, duct-type intake 'hose', I will probably rip that sucker out and see how it goes.
Thanks again to all of you--- as a direct result of your assistance, I saved $100-$300 and the vehicle runs great!!! On top of that, it always feels better when I do the work myself (and I scored big points with the wife...). Take Care, the Reverand
.
Today I took a leap of faith (on your advice) and replaced my MAF Sensor and cleaned the intakes. I tried to get a NEW AC Delco, but the cheapest I found was about $400. So, I found a remanufactured AC Delco at Advanced Auto (with a lifetime warranty) for $157.00. As it turned-out, it was incredibly simple to do the switch (easier than changing spark plugs) and the car runs sOOOOO much better.
As for the MAF screen, I decided to leave it in because it runs good enough for my purposes. However, when I get around to getting a smooth, duct-type intake 'hose', I will probably rip that sucker out and see how it goes.
Thanks again to all of you--- as a direct result of your assistance, I saved $100-$300 and the vehicle runs great!!! On top of that, it always feels better when I do the work myself (and I scored big points with the wife...). Take Care, the Reverand
.
Thread
Thread Starter
Forum
Replies
Last Post
brminder
Performance, Brainstorming & Tuning
21
12-17-2002 01:01 AM