When I got my 96 se green bonneville, the center console flip cover/cup holder were gone (along with the metal hinge) so essentially there is just a hole in between the front two seats in place of the arm rest/console. I'd love to get this back and certainly will need to when the time comes to sell the car. Any suggestions on where to get one and how to install it? :?

P.*. - I saw this post: http://www.bonnevilleclub.com/forum/...light=arm+rest

I need the green one complete with hinges!!

there are 2 pieces that you need....the bezel (plastic with the lid and the cupholder) and then the lid (matched to your color interior)

the guys that have the Books will jump in with the PN'*......

Billboost might have the lid matched to your color.....post up your color interior here so we know....

The color is the green lid (shown in the middle of the 3) in billboost'* post. I'd love to get this replaced it'* been plaguing me for years!

PM received.

I have the actual lid only. Typically the latches are broken off the bottom of them. That is a seperate piece that I do not have.

I think I may need the hinge too? According to this diagram:

http://www.lansingfx.com/hinge.jpg

Assuming this is the hinge that allows the lid to flip up, I do need it.

At the moment..I have the top piece only of diagram 2. That hinge is possible, but you would need to swap over your lower cover w/catch onto the cover I have.