I finally changed the tranny in my '95. Now it runs and drives...

But after we got it back together, it just kills the battery when you run it. You can see the voltage go (like it is charging) then it drops to basically zero then goes back up, over and over till it is completely dead.

I ask my brother if he hooked the wiring harness back up correctly, so he unhooks it and there is a pin bent over. I straightened the pin and plugged it back in, but it is still doing it and I am getting a bunch of codes.

257 Boost Control Failure (overboost)
325 ESC Failure
623 PROM Error
640 QDM 1 Failure
650 QDM 2 Failure

I have been trying to figure out what all these codes mean, but I can only come up with one explination. Bad computer, possibly shorted when the pin was bent?

I just hate to spend $100+ on a new computer and have that not be the problem.

Any ideas? Help me, I miss my Bonny :(

Is your ground cable properly tightened down?

How old is the battery? The battery sounds like the suspect.

i thought it might be the batterytoo, but i used another battery that is pretty much new and it did the same thing