my build, need input
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Feb 2006
Location: PA
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
my build, need input
Im trying to put together a build sheet, I was wandering what you would recommend, i need reliability plus performace, this is my idea so far, s2x cam, 130# valve springs, yella terra rockers/ rods, hydrolic roller lifters, im porting my supercharger and lim, and maybe a 2.6 pulley with stage 1 intercooler? if i dont have enough for the heads which i prolly wont i will go with the s1x cam...Am i on the right track?
this is all for the top swap, i have someone to tune a OBD1 95 if i do not change to pcm, my engine is a series II N/A, not worried about the trans since i have all the parts for an HD for now.
this is all for the top swap, i have someone to tune a OBD1 95 if i do not change to pcm, my engine is a series II N/A, not worried about the trans since i have all the parts for an HD for now.
#4
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Your engine already has roller lifters. I would say go with #105 springs instead of #130. Be sure to install a new timing chain and tensioner. But it sounds like your on the right track.
#5
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
For the record, I'm running a 3.0" pulley. Smaller is not always better. A very good tune will tell you if you can go small. Timing is better the boost, to a point.